Kodak DryView 8300 Service Bulletins page 115

The 8610 LASER IMAGER may also prematurely eject the FILM TRAY if the TRAY unlocks, as it
th
should after the 100
message "REMOVE, LOAD AND INSERT FILM TRAY (30) PRESS ENTER WHEN READY TO
REMOVE TRAY" is displayed on the LOCAL PANEL. The operator then presses the Enter key,
removes the FILM TRAY, loads it with a new bag of film, reinserts the FILM TRAY and presses
Enter within two seconds.
Solution
Advise the operator that the FILM SAVER is not needed to load new film as stated on page 3-2 of the
User Guide.
Advise the operator to wait a full three seconds after inserting the FILM TRAY, before pressing Enter to put
the LASER IMAGER on-line.
Gary Ketch, Service Engineer-Oakdale
For more information please contact:
Printed in the USA. Pub No. 8E6874
©Eastman Kodak Company
Rochester, NY 14650
sheet is fed, but the FILM TRAY stays in place and does not back out. The
Eastman Kodak Company
Health Imaging
1 Imation Way
Discovery Building 3B-62
Oakdale, MN 55128-3414, USA
1-800-328-2910
Kodak and DryView are trademarks.
HEALTH IMAGING