Kodak DryView 8300 Service Bulletins page 100

SERVICE BULLETIN
Health Imaging Products
Eastman Kodak Company, Health Imaging, Rochester, NY 14650
SERVICE BULLETIN NO. 30 JULY 2002
1439 Kodak DryView 8610 LASER IMAGER
Film Calibration Fails Because D-max is Not in Spec
Purpose
The purpose of this service bulletin is to communicate that on the IMAGER the Film Calibration fails and
Debug of the calibration reveals that D-max is less than 3.5.
Cause
After an out of spec DRUM temperature, or outdated FILM has been ruled out, the Motor Control PWA is
probably loading down the laser power.
Solution
1. Verify that the DRUM temperature is in spec.
2. Verify that the FILM is capable of printing at a D-max greater than 3.5 by flashing a sheet to ambient
light for about 5 seconds, let the IMAGER process it and measure the results with a DENSITOMETER.
3. Replace the Motor Control PWA.
ãEastman Kodak Company, 2002
Pub No. 8E6637