Kodak DryView 8300 Service Bulletins page 53

8600 internal flash memory is quite large and it takes a couple of seconds to make a backup copy of
it. The 8600 sends an X-Off to Hyperterminal to buy time, but Hyperterminal can't react fast enough
and bits are dropped. By sending a very short first file that starts the backup copy process,
Hyperterminal does not have to X-Off. By the time the second file is sent, the backup of the 8600
internal flash memory is complete.
2-5. 8600 Installation Checklist
q
Unpack and install the 8600 and 9410 hardware, following the procedure in Section 2 of
the Service Manual.
q
Ensure that the 8600 is configured to accept digital images from the 9410.
q
Set up the 9410 with the IP Address that will put it onto the customer's network.
q
Set up the 9410 SMT SCP Printer and Local Printers parameters.
q
Print a test image from the 9410.
q
Send (or have the operator send) a test image from the modality work station.
q
Confirm that the image is acceptable for the image parameters selected for the OEM
equipment.
q
Train the operators using the Operator Training Guidelines in the back of the 8600 User
Guide.
q
Ask the operator to demonstrate printing a QC step wedge.
q
Ask the operator to print some images that are stored on the user's work station.
q
Get image approvals from the chief radiologist who will be reading films printed on the
8600.
3. Adjustments.
Same as the 8300.
4. Disassembly/Reassembly.
Same as the 8300.