Kodak DryView 8300 Service Bulletins page 32

Service & Support
Health Imaging
Kodak DryView 8300 LASER IMAGERS
Technical Bulletin
13-10/01 Disable Debug after a Service Call
If you use the Debug software (Control+D) during a service call to monitor IMAGER operations such as
calibrating or transporting a film or the temperature of the DRUM, you must disable it before leaving the
account.
If Debug is not disabled, it could cause film calibration to take several minutes longer than normal. Failure
to disable Debug might also cause the IMAGER to beep when there is a small deviation in temperature
readings from the DRUM.
If your COMPUTER is connected to the IMAGER, type [Control+D] to disable Debug. If your
COMPUTER has been disconnected and you don't know if Debug is still active, energize and then
de-energize the IMAGER to disable Debug.
October 2001
Eastman Kodak Company
Health Imaging Products
1 Imation Way
Oakdale, MN 55128
http://www.kodak.com
Printed in the U.S.A.
© Kodak 2001