Kodak DryView 8300 Service Bulletins page 70

3-1/00 Frequent Error Code 27's
Problem: Films stop intermittently in the Processor at various positions for no apparent reason
causing EC27 to be displayed.
Cause: The system software may have timed out because the film took too long to travel through the
Processor.
Solution: First adjust the Processor drive belt to specification (paragraph 3-12 in the Service
Manual). Then remove the non-driven entrance and exit rollers and clean the rubber surface of the
rollers with alcohol. Also clean the roller shafts and associated bearings.
4-1/00 Power Distribution Error and/or Laser Board
Failure with 9410 Connected
Problem: A power distribution error and/or a Laser Board Failure message appears on the 8600
local panel when a 9410 is connected to the host control connector on the 8600.
Cause: The 9410 may be loading down the 8600 power supply.
Solution: Check the position of the +/– 12V CTS/RTS Switch on the Digital Input Module of the
8600. It should be set in the CTS/RTS position. (The +/– 12V position is for keypad control and the
CTS/RTS position is for host control.) To change the position of the switch, power off and use a
ball-point pen to press the white center portion down on the end closest to the CTS/RTS marking on
the circuit board.