Kodak DryView 8300 Service Bulletins page 75

DryView 8600/8610 Laser Imaging System Service Manual
2-8. Unpacking and Setting up the 9410
Unpacking and setup instructions for the 9410 are provided in Section 3 of the 9410 Service Manual. The
basic configuration of the 9410 as installed with the 8600/8610 is as follows:
¯ An image input board is not used. The input cable from the network connects directly to the
DICOM connector on the motherboard.
¯ A COPCIL Copper Output Board is used to drive the 8600/8610.
¯ The system requires an Uninterruptible Power Supply.
¯ A keypad or modem is not required.
The instructions in Section 3 of the 9410 Service Manual include many possible installation
configurations. The following paragraphs attempt to guide you through installation by referring you to the
paragraphs in Section 3 that apply specifically to installation of the 9410 with an 8600/8610.
2-9. Connecting the 9410 to the 8600/8610
1. Turn off 8600/8610 power before proceeding with hookup of the 9410.
2. Before connecting the cables between the COPCIL Board in the 9410 and the Digital Input Module in
the 8600/8610:
a. Remove the right side cover of the 8600/8610 (see paragraph 4-2-1) to expose the Digital Input
Module.
b. Make sure that the switch on the upper right corner of the Digital Input Module that selects either
CTS/RTS or ±12 V is set at the CTS/RTS position (pressed in). (This selects host control rather
than keypad control).
3. See Figure 2-1. Attach the data cable from the COPCIL Board to the 37-pin connector on the
8600/8610 Digital Input Module.
4. Attach the control cable to the 9-pin connector on the Digital Input Module.
Figure 2-1. System Hardware Configuration/Cable Connections
2-6
8600/8610.
8600/8610.
8600/8610
2000 December Rev. B