Kodak DryView 8300 Service Bulletins page 36

Service & Support
Health Imaging
Kodak DryView 8300 LASER IMAGERS
Technical Bulletin
16-12/01 Light-Weight FILM FEED ROLLERS
All new Kodak DryView 8300 LASER IMAGERS are being sent with the same light-weight FILM FEED
ROLLER that has been used in the Kodak DryView 8600 and 8610 LASER IMAGERS. With the light-
weight FILM FEED ROLLER, there will be a reduction in the number of scratches caused when a sheet of
film feeds from the FILM TRAY.
The new light-weight FILM FEED ROLLER 6E8549, which is stocked in Service Parts, includes 4 nylon
SPACERS to install in place of the old ROLLER.
Important
When the new ROLLER is installed, the FILM TRAY might not eject to its full normal position.
After installing the light-weight FILM FEED ROLLER, do the following:
1. Locate the TRAY POSITIONING GUIDE on the left side of the FILM TRAY slot.
2. Remove:
• 2 spring-loaded PADS
• SPRINGS
3. Install the TRAY POSITIONING GUIDE again.
If the new FILM FEED ROLLER cannot feed the last sheets of film in the FILM TRAY, the FILM TRAY
might have to be replaced with a FILM TRAY with lighter-density foam. All of the FILM TRAYS stocked
in Service Parts have FOAM with a lighter density. The new FILM TRAYS can be identified by the ½-in.
Kodak logo on the outside bottom of the TRAY.
December 2001
Eastman Kodak Company
Health Imaging Products
1 Imation Way
Oakdale, MN 55128
http://www.kodak.com
Printed in the U.S.A.
© Kodak 2001