Kodak DryView 8300 Service Bulletins page 44

1-4. Non-Operating Environment
Temperature:
Humidity:
1-5. Hardware Interface (Input Modules)
DICOM – from customer's network into the PACs Link 9410 Acquisition System. Output from 9410 is
Standard Digital into a Digital Input Module on the 8600.
1-6. Interface Control
3M 952 Host Protocol (to accommodate output from PACs Link 9410 Acquisition System, only)
1-7. Memory
32-128 Mb
1-8. Output
First Print (after Ready is achieved)
Subsequent Prints:
Spatial Resolution:
Pixel Size:
Image Sizing:
Maximum Density:
Dynamic Range:
Contrast:
1-9. Film Characteristics
Type:
Size:
Packaged:
Imageable Area:
Imageable Pixels:
Position:
1-10. Agency Compliance
This equipment has been tested for and complies with the following Safety and Emission Standards.
Certificates of Compliance and Declarations of Conformity have been issued for the following
countries:
Australia/New Zealand:
AS/NZS 3548: 1992
AS 2211-1991
AS3200.1-1990/NZS 6150: 1990
–30 C for 96 hours to 65 C for 24 hours
15% RH for 96 hours to 85% for 24 hours
Kodak DryView Mammography Laser Imaging Film
20.3 cm X 25.4 cm (8 in. X 10 in.)
101 sheets
194.72 mm X 240.25 mm
5025 X 6200
Landscape or Portrait
195 seconds
25 Films/Hr.
655 dpi
38.75 microns
True size
Scale to Fit Film
3.5 Optical Density
=< 0.25 to 3.5 OD
Selectable by FE at installation from 11 sets (Modality
Groups) of 12 Look-Up Tables each