Kodak DryView 8300 Service Bulletins page 62

2. Remove the film saver, film, and the liner from the tray.
3. Inspect the inside of the tray, the ramp and the edge of the ramp for possible scratches. Replace
the tray if there are scratches on the ramp or the top edge of the tray.
4. Wipe off the inside of the tray, the ramp, and the ramp edge with cleanroom wipes dampened with
Isopropanol.
5. Inspect the film feed roller. Replace the film feed roller if there is any damage or if it is worn out.
6. Clean the film feed roller with cleanroom wipes dampened with Isopropanol.
5-7-4. Cleaning the Filters
1. Push the right side button and raise the lid.
2. Vacuum the exposed surfaces of the charcoal and faz filters.
3. Remove the charcoal and faz filters from the imager.
4. Wipe off the exit ports of the charcoal and faz filters.
5. Inspect the filters and replace them, if necessary.
Note
According to the current PM schedule, the charcoal filter is replaced every 20,000 cycles and
the FAZ filter is replaced every 60,000 cycles.
5-7-5. Cleaning the Laser Entry Area, Capstan, and Pinch Rollers
1. Remove the three screws holding the laser shield.
2. Remove and clean the laser shield.
3. Remove the three screws holding the left (as viewed from the machine front) side panel of the
imager.
4. Raise the upper wire guide.
5. Vacuum the laser scanning area behind the laser shield.
6. Use an Isopropanol dampened wipe to clean the dust and debris from the capstan and the two
pinch rollers. Do this while slowly rotating the capstan flywheel (which was exposed by opening
the left side panel).
7. Use several pads to clean the rollers to ensure that no visible extraneous material is left on the
rollers. Do not leave any debris in the gap between the two pinch rollers.
8. Lower the wire guide.
9. Put the laser shield back in place and secure it with the screws.