SRX3600 Services Gateway Getting Started Guide
12
Lift the Chassis into the Rack
Lifting the chassis and mounting it in a rack requires two people. The empty chassis
weighs approximately 43.6 lb (19.8 kg).
Ensure that the rack is in its permanent location and is secured to the building.
1.
Position the chassis in front of the rack or cabinet. Use a pallet jack if one is available.
2.
With one person on each side, lift the chassis into position in the rack:
3.
For two-post rack mounting, align the bottom hole in each mounting bracket with
a hole in each rack rail.
For four-post rack or cabinet mounting, position the device so that the bottom rear
edge of the chassis rests on the support shelf that you installed earlier, as shown
in Figure 5 on page 7.
WARNING: Do not attempt to lift the chassis by the handles on the power
supplies or on the Common Form-factor Modules (CFMs). The handles
may break off causing the chassis to fall and inflict injury.
Figure 11: Lift the Chassis into the Rack
Use the screws to attach the left and right brackets to the rack.
4.
Visually inspect the alignment of the chassis. If the chassis is installed properly in the
5.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side, and the chassis should be level.
Copyright © 2011, Juniper Networks, Inc.