Performing A Compliance Film Calibration - AGFA DRYSTAR 5302 Technical Documentation Manual

DD+DIS150.05E
2.5.7

Performing a Compliance Film Calibration

NOTE:
Performing this step is only required, if the column "Deviation compared to DICOM
(%)" for one (or more) value(s) is ≥ 10 %. Refer to section 2.5.6.
With this calibration the printer applies a correction on the current film calibration.
(1) Re-connect the printer to the service PC via network cable.
(2) In the service command session select "6 Calibration – 6 Compliance film
calibration. The wizard as shown in Figure 18 will start.
(3) Select "3 Proceed without resetting"
(4) Select "proceed" (the described steps you performed already – neglect the
instructions in this screen)
(5) Select the upper tray
(6) Select the configured densitometer. Refer to section 2.5.1
(7) Select "Start calibration".
(8) Enter Dmin and Dmax measured during step "2.5.6 Performing the Afssaps /
EUREF Calibration Check"
(9) Leave "Reflected ambient light" and "View Box Illumination" values on default.
(10) Select for number of steps: "18 (EUREF)"
(11) Select "Start calibration".
(12) Enter the values measured in step "2.5.6 Performing the Afssaps / EUREF
Calibration Check"
(13) Repeat this procedure for the lower tray.
*For steps
IMPORTANT:
The browser screen where the 18 data are entered refreshes in a time interval of
1 minute. If you are not finished with entering all data within 1 minute, all entered
values will be reset to default values.
Workaround to avoid entering all data again: Press the "back button" in the browser.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
05-2009
.
4
. See IMPORTANT note below.
7
to
7
2
refer to Figure 18 page 30.
DOCUMENT CONTROL NOTE:
DRYSTAR 5302
Type 5366/100
Adjustments and Calibrations
*.
2
.
3
.
6
Repair and Service
.
5
Chapter 3.6 / 28
Agfa Company Confidential