AGFA DRYSTAR 5302 Technical Documentation Manual page 147

DD+DIS150.05E
The reader should always refer to MedNet to ensure that they are working with the latest copy of the document.
Edition 1, Revision 0
2005-09-09
Machine specific tools, software tools and auxiliary means
(1) Disconnect the printer from the
network.
(2) Give the IP address of the
service PC the same IP address
like the printer*
(3) Start ADVP
(4) Select 'Basic Grayscale' in the
'Start up configuration' screen.
(5) Select 'Application - Print
Emulator - Start'
(6) In the following window fill in
- Called (Printer) AE Title (this is
the AE title of the printer),
- 'Called (Host) AE Title'
- ADVP Listen port (usually 104:
this is the port the modality
sends DICOM messages).
(7) Select okay. Now ADVP is
prepared for recording the
communication between
modality and the printer.
*In case ADVP runs on the printer, just select 'Stop Controller' to stop the
application software (and so switch off the DICOM SCP functionality of the
printer). When communication recording is finished, close ADVP and select
'Start Controller'.
Printed copies of this document are not controlled.
Drystar 5302
(Type 5366/100)
Repair and Service
Figure 47: ADVP as Print Emulator
Agfa Company Confidential
Chapter 3.2/45