Emergency Sw Installation On A Printer In "Error - System Failure" State - AGFA DRYSTAR 5302 Technical Documentation Manual

Repair and Service
Machine specific tools, software tools and auxiliary means
3.3
Purpose
The reader should always refer to MedNet to ensure that they are working with the latest copy of the document.
Chapter 3.2/52
Agfa Company Confidential
The printer "Emergency_Install" software can be obtained via MEDNET,
GSO Library.
Caution:
•
Depending on the software patch version it might be possible, that
one of the boards gets re-programmed during the software upgrade.
•
In case this re-programming is interrupted by power loss, this specific
board may become unusable.
•
Do not reboot the printer before requested by a local keypad
message
Emergency SW Installation on a printer in "Error - System Failure"
state
This chapter describes the SW Installation on a printer in ERROR -
SYSTEM FAILURE state.
Important remark:
The software installation procedure
described here formats the hard
disk.
In case you select "NO" at question
"Do you want to preserve config"
the configuration data are erased.
In this case the printer is only in the
same state than before, if an up-to-
date backup is available.
In case the CF card is lost or not
readable the complete printer setup
has to be redone.
Printed copies of this document are not controlled.
(Type 5366/100)
Drystar 5302
DD+DIS150.05E
Emergency SW FOUND
ON EXTERNAL CF-card
Install emergency
SW? YES (V) NO (X)
Emergency SW Install
Do you want
to preserve config?
YES (V) NO (X)
536632gc.cdr
Figure 54
Edition 1, Revision 0
2005-09-09