Solved Bug In Software 2.0.0_C2 - AGFA DRYSTAR 5302 Technical Documentation Manual

DD+DIS150.05E

Extended operating System and Browser Compatibility of the Operator, Key-
Operator and Service Browser Pages.
Supported operating systems:
- Windows 2000
- Windows XP
- Windows Vista
Supported browsers:
- Internet Explorer 6, 7 and 8
- Firefox 3

Support of Resistor Check Function. This function allows troubleshooting of film
stripes in the film run direction.
9.2

Solved Bug in Software 2.0.0_C2

Symptom 1
Sporadically the printer stops boot-up with message "Error System Failure":

When pressing the ON/OFF switch the printer cannot be switched off.

Access via network is not possible (to reboot remotely).

After unplugging and reconnecting the mains cable the printer usually starts up
normally.
CPU Driver problem
Cause
Solution
Install software 2.0.0_C2 to prevent the problem.
Symptom 2
Infocounter data and E-Label data sporadically do not match.
E-Label and Infocounter synchronization problem
Cause
Install software 2.0.0_C2.
Solution
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2011
NOTE:
For DRYSTAR 5302 software patch 1.9.2_C1 solved already most cases of
the problems.
DOCUMENT CONTROL NOTE:
Software Releases and Patches
DRYSTAR 5302
Type 5366/100
Repair and Service
Chapter 3.8 / 18
Agfa Company Confidential