AGFA DRYSTAR 5302 Technical Documentation Manual page 56

Controls, Connections and Set Up Procedures
The reader should always refer to MedNet to ensure that they are working with the latest copy of the document.
Chapter 1 / 22
Agfa Company Confidential
The printer switches automatically to cubic Bell interpolation by evaluation of
the DICOM communication when no image scaling (i.e. magnification or
reduction) is required:
Cubic HighRes interpolation type does not sharpen the image.
Interpolation type 'Cubic Bell' sharpens the image however, independent
whether scaling is required or not.
This automatic switching is only performed in case the Interpolation Type is
adjusted to 'cubic high res' in the user profile (= default).
This behavior can be switched off via browser pages: Path "Service Tools -
Scaling Setup"
Printed copies of this document are not controlled.
Drystar 5302
(Typ 5366/100)
HOME HELP Controller Setup
yes
Reduction icon on image:
Kernel: when no image scaling is needed for CubicHighRes:
Automatically switch to CubicBell:
Use CubicBell smooth factor: 0.9
OK
Changes require reboot
Figure 15
DD+DIS150.05E
yes
( >= 0.1 and <= 10 )
536401GN.CDR
Edition 1, Revision 0
2005-09-09