Shutdown - Cisco Nexus 5000 Series Command Reference Manual

shutdown

shutdown
To shut down the local traffic on an interface, use the shutdown command. To return the interface to its
default operational state, use the no form of this command.
shutdown
no shutdown
Syntax Description
This command has no arguments or keywords.
Command Default
Not shut down
Command Modes
Interface configuration mode
Subinterface configuration mode
Virtual Ethernet interface configuration mode
Command History
Release
4.0(0)N1(1a)
5.0(3)N1(1)
5.1(3)N1(1)
Usage Guidelines
You can use this command on the following interfaces:
• Layer 2 interface (Ethernet interface, EtherChannel interface, subinterface)
• Layer 3 interface
Use the no switchport command to configure an interface as a Layer 3 interface.
Note
• Layer 3 subinterface
• Management interface
• Virtual Ethernet interface
Cisco Nexus 5000 Series Interfaces Command Reference
88
Modification
This command was introduced.
Support for Layer 3 interfaces and subinterfaces, and virtual Ethernet
interface was added.
Support for virtual Ethernet interface was added.
S Commands