Wiring For Connection Between Components; Organization - Xerox DOCUPRINT N17 Service Manual

6.2.2 Wiring for Connection between Components

6.2.2.1 Organization

The general connection and wiring diagram is divided into the following 19 blocks and the wiring and signals
between the components in each blocks are described.
1. LVPS ↔ MCU
2. LVPS ↔ Feed Solenoid 1, Turn Clutch, and MBF Feed Solenoid
3. LVPS ↔ MBF No Paper Sensor, Registration Sensor, and Toner Empty Sensor
4. LVPS ↔ Envelope Feeder Unit
5. MCU HVPS
6. HVPS EP Cartridge, Bias Transfer Roll, Detack Saw
7. HVPS ↔ Fuser PWB
8. Fuser PWB ↔ Fuser Unit
9. Fuser PWB ↔ Duplex PWB ↔ Duplex Motor and Feeder Sensor
10. MCU ↔ LDD and Scanner Motor
11. MCU ↔ SOS
12. MCU ↔ Control Panel
13. MCU ↔ Main Motor
14. MCU ↔ Fan Motor
15. MCU ↔ Exit Motor
16. MCU ↔ Full Stack Sensor and Rear Cover Sensor
17. MCU ↔ Deck1 PWB ↔ Deck2 PWB ↔ Deck3 PWB
18. OCT PWA ↔ OCT Stack Sensor, OCT Home Sensor, OCT Direct Solenoid, OCT Motor, and OCT Offset
Motor
19. MCU ↔ ESS and LVPS ↔ ESS
Xerox DocuPrint N17 Service Manual
6/98
www.printcopy.info
6-11 Wiring Data