Clearance Space Requirements; Shared Space Between Components; Shared Space Configuration Diagrams - Xerox DocuPrint 100 Installation Planning Manual

Clearance space requirements

Back-to-back
shared space
Installation Planning Guide
• Floor leveling
The printer must be installed in a fixed location that provides the
following clearance space:
• 36 inches / 91.4 cm on all sides of each component
• 78 inches / 198 cm of vertical clearance throughout the entire
area
• 24 inches / 61 cm of exclusive operator area in front of each
component
NOTE: There must be a total of 50 inches / 126.9 cm of clearance
space in front of the printer.

Shared space between components

It is best to provide the full amount of clearance space around the
hardware components. Your environment may require you to use
shared space between components such as between the printer
and the controller or between the printer and another Xerox
printing system. You can share the 36-inch / 91.4 cm clearance
space around each component, as long as you follow these rules:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch / 91.4 cm general service
clearance areas, but they may not share the 24-inch / 61 cm
operator area in front of each component.
• There must be 78 inches / 198 cm of vertical clearance
throughout the entire area.
NOTE: Finishers that are attached to your bypass transport may
occupy shared space with Xerox equipment. However, they must
be removable to allow servicing of the printer feeders and
stackers. Consult with your Xerox representative to ensure all the
requirements are met.

Shared space configuration diagrams

The following figures illustrate three possible configurations of
shared space.
The figure below illustrates the two printers placed in a back-to-
back position. This allows the printers to share the entire 36
inches /
91.4 cm of general service space.
Printer requirements and specifications
6- 15