Exit Gate - Xerox DOCUPRINT N17 Service Manual

4.9.3 Exit Gate

Removal
1 Remove the Top Cover Assembly ( REP 4.2.6 Top Cover Assembly ).
2 Turn the Top Cover Assembly over.
3 Remove the four screws securing the Exit Assembly, and remove the Assembly from the Top
Cover Assembly.
4 Bend the Exit Gate to remove the Gate from the Exit Motor end of the Exit Assembly.
5 Unlatch the shaft on the Direction Spring side of the Exit Gate, and remove the Gate and
Direction Spring from the Exit Assembly.
6 Remove the Direction Spring from the Exit Gate.
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
Figure 4.9.3.1 Exit Gate Removal
SAS450F.CDR
6/98
www.printcopy.info
4-45
sas450fa
Repair/Adjustment Procedures