Paper Tray (Tray I); Paper Size Sensor - Xerox DOCUPRINT N17 Service Manual

4.4 Paper Tray (Tray I)

4.4.1 Paper Size Sensor

Removal
1 Remove the Paper Tray.
2 Remove the Rear Cover ( REP 4.2.1 Rear Cover ).
3 Remove the Left Cover ( REP 4.2.2 Left Cover ).
4 Remove the Front Cover Assembly ( REP 4.2.4 Front Cover Assembly ).
5 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).
6 Remove the System Controller Chassis ( REP 4.12.1 System Controller Chassis ).
7 Disconnect the Paper Size Sensor connector (P/J 135). (See Figure 4.4.1.1.)
8 Press the round clip and the Paper Size Sensor Assembly Stop from the System Controller side
to the paper tray side; then slide the Paper Size Sensor towards the front and remove it.
P/J135
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
Figure 4.4.1.1 Paper Size Sensor Removal
SAS413F.CDR
6/98
www.printcopy.info
4-19
SAS414FA
Repair/Adjustment Procedures