Connector Chute - Xerox DOCUPRINT N17 Service Manual

10.3.5 Connector Chute

Removal
1 Remove the Duplex Module ( REP 10.3.1 Duplex Module ).
2 Remove the one screw which secures the Connector Chute to the Duplex Module.
3 Press inward the two claws which retain the Duplex Harness Assembly to disengage and detach
the Duplex Harness Assembly from the Connector Chute.
NOTE: Leave the Duplex Harness Assembly detached.
4 Shift/pry the Connector Chute slightly to the right to disengage the pin in the inside of the right
end of the Connector Chute from the Duplex Module.
5 Pull the Connector Chute off the indentations of the Duplex Module.
Duplex Harness
Assembly
Replacement
Perform the removal steps in reverse order.
Duplex Module Option
Claws
Pin
Figure 10.3.5.1 Removing the Connector Chute
6/98
www.printcopy.info
10-12
SAS486F
Xerox DocuPrint N17 Service Manual