Env. Feeder Empty Message (C5) - Xerox DOCUPRINT N17 Service Manual

11.8.2 Env. Feeder Empty Message (C5)

1 Verify the No Paper Actuator moves freely. The Actuator moves freely.
Y: Go to step 2.
N: Replace the No Paper Actuator.
2 Enter Diagnostic Mode 1 - Sensor Input Test, and verify the operation of the No Paper Sensor.
The No Paper Sensor operates properly.
Y: Replace the Print Engine Controller.
N: Go to step 3.
3 Remove Envelope Feeder and verify continuity of the Envelope Feeder Harness. The continuity
of the Harness is good.
Y: Go to step 4.
N: Replace Envelope Harness Assembly.
4 Enter the Diagnostic Mode 1, Input Sensor Test, and momentarily ground P201-4 (Bottom
Portion of Connector, Center Pin) twice. The UI indicates sensor actuation.
Y: Replace the Low Paper Sensor.
N: Troubleshoot the electrical wiring from the Print Engine Controller (P/J13) to P201
using Wiring Data in Section 6.2.3 (LVPS to ENVELOPE FEEDER UNIT). Repair or
replace faulty component(s).
Xerox DocuPrint N17 Service Manual
6/98
www.printcopy.info
11-37 Envelope Feeder Option