Lower Chute/Full Stack Sensor/Full Stack Actuator - Xerox DOCUPRINT N17 Service Manual

9.3.6 Lower Chute/Full Stack Sensor/Full Stack Actuator

Removal
1 Remove the Exit Chute Assembly ( REP 9.3.4 Exit Chute Assembly) .
2 Push back a portion of the H Earth Plate that lowers the Eliminator.
3 Press the latches securing the Eliminator and detach the Eliminator from the Exit Chute
Assembly.
4 Pull the Full Stack Actuator out of the bearings at both sides.
5 Disconnect the harness of the Full Stack Sensor.
6 Press the latches of the Full Stack Sensor to detach the Full Stack Sensor from the Lower Chute.
7 Remove the two screws which fasten the Lower Chute.
8 Lift off the Lower Chute.
Figure 9.3.6.1 Removing the Lower Chute/Full Stack Sensor/Full Stack Actuator
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
6/98
www.printcopy.info
9-13
SAS4A7FA
Offset Catch Tray (OCT) Option