Tray Empty Sensor - Xerox DOCUPRINT N17 Service Manual

Hide thumbs Also See for DOCUPRINT N17:

Table of Contents

12.6.6 Tray Empty Sensor

1. Disconnect the AC power and remove the Rear Access Cover.

2. Disconnect P/J4 from the Controller PWB. Reconnect the AC power.

Measure the voltages listed in Table 1 at J4 on the Controller PWB. All

voltages are correct.

Go to step 3.

N: Replace the Controller PWB (12.2.3).

3. Disconnect the AC power. Reconnect P/J4 and reconnect AC power.

Measure the voltages listed in Table 2. All voltages are correct.

Go to step 4.

N: Check the wiring between the Tray Empty Sensor and P4. If OK, replace

the Sensor (12.2.4).

4. Replace the Controller PWB (12.2.3).

Xerox DocuPrint N17 Service Manual

Table 12.6.6.1 Tray Empty Sensor

Table 12.6.6.2 Tray Empty Sensor

www.printcopy.info

Sensor Actuated

Sensor Deactuated

Denotes Pin #1

High Capacity Feeder Option

Table of Contents