Notations In The Rep Text; Before You Start Any Rep - Xerox DOCUPRINT N17 Service Manual

4.1.1 Notations in the REP Text

Locations given in the REPs assume you are facing the Control Panel with the following orientation:
The following notations apply:
• Arrows in the illustrations show direction of movement. Follow the numerical order if the
arrows are numbered.
• The notation screw (number, type, length of thread) identifies individual screws.
• The notation REP X.Y in a REP step directs you to another REP to see how to perform a
related procedure.
• The notation Figure X.Y references the illustration corresponding to the REP you are
performing.
• A number followed by a parenthesis, e.g., 8), references the corresponding REP step.

4.1.2 Before You Start Any REP

There are a number of steps you should follow before you begin any procedure:
1 If applicable, cancel pending jobs and take the printer offline.
2 Switch the printer main power OFF, and disconnect the power cord from the wall outlet.
3 Remove the EP Cartridge from the printer; and store it in a safe, dark place.
4 Do not use force to remove or install printer components.
5 Use only the screw size and type designated in the REP. The wrong screw could easily damage
tapped holes.
6 Wear a wrist strap to dissipate static electricity, which may damage sensitive electronic parts.
7 See Section 6 , Wiring Diagrams, for detailed wiring diagrams.
Repair/Adjustment Procedures
Figure 4.1.1.1 Printer Orientation
Left
Front
www.printcopy.info
6/98
4-6 Xerox DocuPrint N17 Service Manual
Rear
Right