10.3.2 Direction Chute and Upper Chute
Removal
1 Remove the Duplex Module ( REP 10.3.1 Duplex Module ).
2 Raise the left end of the Direction Chute off the holder, then slide the Direction Chute to the left in
the direction of the axis to take the right end off the holder.
3 Remove the two screws which secure the Upper Chute to the Duplex Module.
4 Lift off the Upper Chute.
SAS495F
Figure 10.3.2.1 Removing the Direction Chute and the Upper Chute
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
Direction Chute
6/98
www.printcopy.info
10-9
Upper Chute
Duplex Module Option