Btr Chute Assembly - Xerox DOCUPRINT N17 Service Manual

4.7.2 BTR Chute Assembly

Removal
1 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).
2 Remove the two screws securing the BTR Chute Assembly. (See Figure 4.7.2.1.)
3 Remove the two screws securing the HVPS leads.
4 Remove the Duplex Module, if present.
5 Remove the Fuser Module ( REP 4.8.1 Fuser Assembly (CRU) ).
6 Remove the rear screw securing the BTR Chute Assembly to the Frame.
7 Lift the BTR Chute Assembly upward and remove it.
Red
Pink
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
Figure 4.7.2.1 BTR Chute Assembly removal
SAS436F.CDR
6/98
www.printcopy.info
4-41
SAS436FC
Repair/Adjustment Procedures