Envelope Feeder Reps; Before You Start Any Rep - Xerox DOCUPRINT N17 Service Manual

11.3 Envelope Feeder REPS

This section explains the removal and replacement procedures (REPS) for the Envelope Feeder parts
which are listed in Section 11.2 Envelope Feeder Parts List .
NOTE: Parts listed on the parts list that do not have a REP can be easily removed and replaced without
a procedure. However, carefully look at how they are installed before removing them.

11.3.1 Before You Start Any REP

There are a number of steps you should follow before you begin any procedure:
1. If applicable, cancel pending jobs and take the printer offline.
2. Switch OFF the printer main power and disconnect the power cord from the wall outlet.
3. Do not use force to remove or install printer or Envelope Feeder components.
4. Use only the screw size and type designated in the REP. The wrong screw could easily damage
tapped holes.
5. Wear a wrist strap to dissipate static electricity which may damage sensitive electronic parts.
6. See Section 6, Wiring Diagrams, for detailed wiring diagrams.
Envelope Feeder Option
6/98
www.printcopy.info
11-8 Xerox DocuPrint N17 Service Manual