Retard Holder/Retard Main Spring/Retard Roll Assembly - Xerox DOCUPRINT N17 Service Manual

11.3.11 Retard Holder/Retard Main Spring/Retard Roll Assembly

Removal
1. Remove the Top Cover (REP 11.3.7).
2. Set the Top Cover upside down.
3. Hold and depress the gear-side portion of the Retard Roll Assembly (See (1) in Figure 11.3.11.1) to
allow its opposite portion to disengage from the hooks on the Top Cover (See (2) in Figure 11.3.11.1)
while holding the opposite side and raise it about 3 cm, then remove the whole assembly in an angu-
larly upward motion (See (3) in Figure 11.3.11.1).
4. Slide the Feeder Bearings and the Retard Roll Assembly together about 4 mm to the gear side to let
the Bearings come off the bearing holes at the Retard Gear Holder side (See (4) in Figure 11.3.11.2)
and lift up the Feed Bearings and the Retard Roll Assembly toward the gear side (See (5) in Figure
11.3.11.2) from the Retard Holder (See (6) in Figure 11.3.11.2).
5. Separate the Feeder Bearings from the Transfer Roll Assembly (See (7) in Figure 11.3.11.2).
6. Remove the Retard Main Spring from the Retard Holder (See (8) in Figure 11.3.11.2).
1
Figure 11.3.11.1 Retard Holder & Retard Roll Assembly Removal
Envelope Feeder Option
2
FRONT
6/98
www.printcopy.info
11-22
3
Xerox DocuPrint N17 Service Manual
SAS4D0FA