Front Tray Chute Assembly - Xerox DOCUPRINT N17 Service Manual

4.6.4 Front Tray Chute Assembly

Removal
1 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).
2 Remove the Inlet Chute Assembly ( REP 4.6.2 Inlet Chute Assembly ).
3 Remove the screw securing the Front Tray Chute Assembly on the right.
4 Bias the Front Tray Chute Assembly towards the right while pulling upward, and then remove the
assembly.
Replacement
1 Compress the Bottom Tray until it stops.
2 Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
Figure 4.6.4.1 Front Tray Chute Assembly Removal
SAS422F.CDR
www.printcopy.info
6/98
4-27
SAS422FA
Repair/Adjustment Procedures