High Capacity Feeder Reps - Xerox DOCUPRINT N17 Service Manual

12.3 High Capacity Feeder REPS

This section explains the removal and replacement procedures (REPS) for the High Capacity Feeder
parts which are listed in Section 12.2 High Capacity Feeder Parts List .
NOTE: Parts listed on the parts list that do not have a REP can be easily removed and replaced without
a procedure. However, carefully look at how they are installed before removing them.
There are a number of steps you should follow before you begin any procedure:
1. If applicable, cancel pending jobs and take the printer offline.
2. Switch OFF the printer main power and disconnect the power cord from the wall outlet.
3. Do not use force to remove or install printer or High Capacity Feeder components.
4. Use only the screw size and type designated in the REP. The wrong screw could easily damage
tapped holes.
5. Wear a wrist strap to dissipate static electricity which may damage sensitive electronic parts.
6. The terms elevator, elevator tray, and paper tray are used interchangeably.
7. See 12.5, Wiring Diagrams, for detailed wiring diagrams.
High Capacity Feeder Option
6/98
www.printcopy.info
12-10 Xerox DocuPrint N17 Service Manual