Setting The Hunt Delay - Nortel Modular ICS 4.0 Manual

‡¤‡fi°‡
3. Press
'
Terminals&Sets.
4. Press
≠
prgrming.
≠
5. Press
6. Press
≠
7. Enter the Hunt Group number you want to program (1-30).
'
8. Press
9. Press
10. Press CHANGE to set the mode: Sequential, Rotary,
®
Broadcast.
11. Press

Setting the hunt delay

This setting allows you to program the number of rings the
system permits at a Hunt Group set before moving on to the
next set in the Hunt Group.
1. Place the programming overlay on any M7310 or M7324
ƒ••¤flfl‹››
telephone.
2. Press
‡¤‡fi°‡
The display shows Password:.
3. Press
'
Terminals&Sets.
4. Press
≠
prgrming.
≠
5. Press
6. Press
7. Enter the Hunt Group number you want to program (1-30).
P0881591 Issue 01
until the display shows System
. The display shows Hunt groups.
. The display shows Show group.
. The display shows Member DNs:.
until the display shows Mode.
'
to exit or
until the display shows System
. The display shows Hunt groups.
. The display shows Show group.
Programming Hunt Groups / 141
(SCPLUS). The display shows
to continue programming.
(SCPLUS). The display shows
Modular ICS 4.0 System Coordinator Guide
(CONFIG).