Changing User Speed Dial - Nortel Modular ICS 4.0 Manual

130 / User Preferences
Use the display buttons to change the programming for a
button. User Preferences programming cannot change the
buttons that are used by lines, intercom, and the handsfree
feature.
The display buttons used in button programming.
CANCL
CLR
TEL#
CHANGE
FEATR
FIND
LIST
Information about individual displays is described on page
132.
≠

Changing User Speed Dial

1. Press
'
the number of speed dial codes that are available.
'
2. Press
≠
3. Press
4. Press
5. Press CHANGE and enter the telephone number the same
way you would dial it on the telephone.
6. Press OK.
Modular ICS 4.0 System Coordinator Guide
Moves you out of a setting without making any changes to it.
Erases the button.
Programs the key as an autodial number for an internal or an
external number. If it is an external autodial number, you
must choose a line, line pool, or the routing table for the call
to use.
Used when you are setting up an external autodial number.
Press CHANGE until you see the type of line or pool you want
the number to use.
Press to store a feature code on the button.
Locates a specific button on a telephone by entering its
number. Button numbers are shown in the illustrations.
Takes you to a list of feature codes. Press
through the list and press OK when you see the feature you
want to program on the button.
at User Speed Dial. The display shows
to see the first speed dial code (71).
to move through all the speed dial codes.
at the code you want to change.
'
to move
P0881591 Issue 01