Setting The Hunt Delay - Nortel Modular ICS 6.0 Manual

168 / Programming Hunt Groups
1. Place the appropriate programming overlay on the set you
are using to do programming.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û Ü ß Ý ß
3. Press
Terminals&Sets.
4. Press ' until the display shows System
prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ≠. The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press ≠. The display shows Member DNs:.
9. Press ' until the display shows Mode.
10. Press CHANGE to set the mode: Sequential, Rotary,
Broadcast.
¨
11. Press

Setting the hunt delay

This setting allows you to program the number of rings the
system permits at a Hunt Group set before moving on to the
next set in the Hunt Group.
1. Place the appropriate programming overlay on the set you
are using to do programming.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û Ü ß Ý ß
3. Press
Terminals&Sets.
Modular ICS 6.0 System Coordinator Guide
(ADMIN). The display shows
to exit or ' to continue programming.
(ADMIN). The display shows
(CONFIG). The
(CONFIG). The
P0992640 03