Programming The Queue Time-Out - Nortel Modular ICS 4.0 Manual

Modular system coordinator guide
Table of Contents

Advertisement

6. Press
7. Enter the Hunt Group number you want to program (1-30).
'
8. Press
9. Press
10. Press CHANGE to set the mode: BusyTone, Overflow,
®
Queue.
11. Press

Programming the queue time-out

This setting allows you to program the number of seconds a
call remains in the Hunt Group queue before it is routed to the
overflow position.
1. Place the programming overlay on any M7310 or M7324
ƒ••¤flfl‹››
telephone.
2. Press
‡¤‡fi°‡
The display shows Password:.
3. Press
'
Terminals&Sets.
4. Press
prgrming.
5. Press
6. Press
7. Enter the Hunt Group number you want to program (1-30).
'
8. Press
9. Press
10. Press CHANGE to set the queue time-out: 15, 30, 45, 60,
®
120, 180.
11. Press
P0881591 Issue 01
. The display shows Show group.
. The display shows Member DNs:.
until the display shows If busy:.
'
to exit or
until the display shows System
. The display shows Hunt groups.
. The display shows Show group.
. The display shows Member DNs:.
until the display shows Q Timeout:.
'
to exit or
Programming Hunt Groups / 143
to continue programming.
(SCPLUS). The display shows
to continue programming.
Modular ICS 4.0 System Coordinator Guide
(CONFIG).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ics 4.0

Table of Contents