Using The Buttons Under The Display - Nortel Modular ICS 4.0 Manual

Modular system coordinator guide
Table of Contents

Advertisement

1
Dial pad
2
Display
3
Display buttons
4
Memory buttons
5
Dual memory buttons
6
Shift button
7
Feature button
8
Hold button
9
Release button
The M7324 is different from the M7310 in two ways: it does not
have dual memory buttons (item 5) or a shift button (item 6).

Using the buttons under the display

The three display buttons are used both for telephone features
and programming, but what each button does depends on what
the display shows. Some display instructions that you may see
when making changes on the system are OK, CHANGE or COPY. In
this guide, display button instructions are underlined.
Display buttons
P0881591 Issue 01
Getting started with Norstar / 5
Used for dialing numbers when you are making
calls. It's also used for entering numbers and
letters when you're programming.
Shows instructions for everyday calling as well as
for programming.
Have a variety of uses. The current use is shown
on the display above each button.
Dial a number or feature code stored on the
button.
Can store two numbers or feature codes (used
with the shift button).
Press the shift button before a dual memory
button to activate the second number or feature
code stored on a dual memory button.
Allows you to enter a feature code while using or
programming the telephone.
Puts an active call on hold.
Hangs up an active call or ends programming.
display button
Modular ICS 4.0 System Coordinator Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ics 4.0

Table of Contents