About Setting Up Off-Premise Message Notification To A Pager Number - Nortel Call Center Telephone Administration Manual

84 Chapter 7 Off-premise Message Notification
About setting up Off-premise Message Notification to a pager
number
Example of a destination pager number
If you are assigning a pager destination number from behind a PBX, remember to insert a ·
(depending on your system) before the £ to access an outside line.
There is a combined limit of 30 characters for the pager telephone number and the pager message.
For example, to reach your pager, enter:
£›¤fififi⁄¤‹›£‹
where:
£ specifies the next digits are special characters
•
› recognizes dial tone
•
¤ specifies that the next digits are the numbers to be dialed
•
fififi⁄¤‹› is the pager telephone number dialed
•
‹ inserts a timed pause
•
Depending on the company supplying your paging service, the programming sequence can vary.
For more information about setting the destination telephone number parameters for your pager,
contact your pager company.
To set up Off-premise Message Notification to a pager
N0025637 01
≤
·°⁄.
1
Press
Follow the voice prompts or the display button options to open the
skillset mailbox.
2 If you use the CallPilot interface:
Press °fi to open the Mailbox Tools
•
Press NOTIF or ¤ to open the Off-premise Message
•
Notification menu
• Go to step 3
If you use the Norstar Voice Mail interface:
Press ADMIN or °
•
Press fl to open the Off-premise Message Notification
•
menu
• Go to step 3