Displaying The Aaa Configuration; Saving The Configuration - Nortel 2300 Series Configuration Manual

Displaying the AAA Configuration

To display your AAA configuration, type the following command:
23x0# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server
-------------------------------------------------------------------
r1
Server groups
sg1: r1
set authentication console * local
set authentication admin * local
set accounting admin Geetha stop-only local
set accounting admin * start-stop local
user Geetha
Password = 1214253d1d19 (encrypted)
(For information about the fields in the output, see the Nortel WLAN Security Switch 2300 Software Command
Reference.)

Saving the Configuration

You must save the configuration for all commands that you enter and want to use for future sessions. After you enter the
administrator's AAA configuration, type the following command to maintain these commands in WSS nonvolatile
memory:
23x0# save config
success: configuration saved.
You can also specify a filename for the configuration—for example, configday. To do this, type the following command:
23x0# save config configday
Configuration saved to configday.
You must type the save config command to save all configuration changes since the last time you rebooted the WSS
switch or saved the configuration. If the WSS switch is rebooted before you have saved the configuration, all changes
are lost.
You can also type the load config command, which reloads the WSS switch to the last saved configuration or loads a
particular configuration filename. (For more information, see
Configuring AAA for Administrative and Local Access 65
Addr
192.168.253.1
"Managing Configuration Files" on page
Nortel WLAN Security Switch 2300 Series Configuration Guide
Ports T/o Tries Dead State
1812 1813 5 3 0 UP
526.)