Verifying Ethernet Port Configuration - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Verifying Ethernet Port Configuration

Verifying Ethernet Port Configuration
To display information about Ethernet port configuration settings, use the show commands listed in the
following table.
show interfaces flow control
show interfaces
show interfaces accounting
show interfaces counters
show interfaces counters
errors
show interfaces collisions
show interfaces status
show interfaces port
show interfaces ifg
show interfaces flood rate
show interfaces traffic
show interfaces capability
show interfaces hybrid
show interfaces hybrid status
show interfaces hybrid flow
control
show interfaces hybrid
capability
show interfaces hybrid
accounting
show interfaces hybrid
counters
show interfaces hybrid
counters errors
show interfaces hybrid
collisions
show interfaces hybrid traffic
show interfaces hybrid port
show interfaces hybrid flood
rate
show interfaces hybrid ifg
These commands can be quite useful in troubleshooting and resolving potential configuration issues or
problems on your switch. For more information about the resulting displays from these commands, see the
OmniSwitch CLI Reference Guide.
page 1-26
Displays interface flow control wait time settings in nanoseconds.
Displays general interface information, such as hardware, MAC
address, input and output errors.
Displays interface accounting information.
Displays interface counters information.
Displays interface error frame information for Ethernet and Fast
Ethernet ports.
Displays collision statistics information for Ethernet and Fast Ethernet
ports.
Displays line status information.
Displays port status information.
Displays inter-frame gap values.
Displays peak flood rate settings.
Displays interface traffic statistics.
Displays auto negotiation, flow, speed, duplex, and crossover settings.
Displays general interface information (e.g., hardware, MAC address,
input errors, output errors) for combo ports.
Displays line status information for combo ports.
Displays interface flow control wait time settings in nanoseconds for
combo ports.
Displays auto negotiation, flow, speed, duplex, and crossover settings
for combo ports.
Displays interface accounting information (e.g., packets received/trans-
mitted, deferred frames received) for combo ports.
Displays interface counters information (e.g., unicast, broadcast, multi-
cast packets received/transmitted) for combo ports.
Displays interface error frame information (e.g., CRC errors, transit
errors, receive errors) for combo ports.
Displays interface collision information (e.g., number of collisions,
number of retries) for combo ports.
Displays interface traffic statistics for combo ports.
Displays interface port status (up or down) for combo ports.
Displays interface peak flood rate settings for combo ports.
Displays interface inter-frame gap values for combo ports.
OmniSwitch 6800 Series Network Configuration Guide
Configuring Ethernet Ports
November 2004