Clearing The Qos Log; Classifying Bridged Traffic As Layer 3; Setting The Statistics Interval; Returning The Global Configuration To Defaults - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring Global QoS Parameters

Clearing the QoS Log

The QoS log can get large if invalid rules are configured on the switch, or if a lot of QoS events have taken
place. Clearing the log makes the file easier to manage.
To clear the QoS log, use the
-> qos clear log
All the current lines in the QoS log are deleted.

Classifying Bridged Traffic as Layer 3

In some network configurations you may want to force the switch to classify bridged traffic as routed
(Layer 3) traffic. Typically this option is used for QoS filtering. See
more information about filtering.
The Layer 3 classification of bridged traffic is no different from the classification of normal Layer 3 routed
traffic. Note that Layer 3 classification of bridged traffic is always done. As a result,
Layer 3 ACLs are always effected on bridged traffic.
•
The switch may bridge and route traffic to the same destination.
•
Bridged IP packets are prioritized based on ToS, not 802.1p.
•
The qos classifyl3 bridged
•
bridged at L3 field will always show the status of this parameter set to yes.
Note that Layer 3 ACLs are effected on bridged IP traffic and Layer 2 ACLs are effected on routed traffic.

Setting the Statistics Interval

To change how often the switch polls the network interfaces for QoS statistics, use the
command with the desired interval time in seconds. The default is 60 seconds. For example:
-> qos stats interval 30
Statistics are displayed through the show qos statistics command. For more information about this
command, see the OmniSwitch CLI Reference Guide.

Returning the Global Configuration to Defaults

To return the global QoS configuration to its default settings, use the
will then be active on the switch. For a list of global defaults, see
Note. The qos reset command only affects the global configuration. It does not affect any policy configu-
ration.
page 21-16
qos clear log command. For example:
command is not available and the
OmniSwitch 6800 Series Network Configuration Guide
Chapter 22, "Configuring ACLs,"
show qos config output display Classify
qos stats interval
qos reset command. The defaults
"QoS Defaults" on page
Configuring QoS
for
21-8.
November 2004