Configuring Ethernet Ports
Verifying Ethernet Port Configuration
To display information about Ethernet port configuration settings, use the show commands listed in the
following table.
show interfaces flow control
show interfaces
show interfaces accounting
show interfaces counters
show interfaces counters
errors
show interfaces collisions
show interfaces status
show interfaces port
show interfaces ifg
show interfaces flood rate
show interfaces traffic
show interfaces capability
These commands can be quite useful in troubleshooting and resolving potential configuration issues or
problems on your switch. For more information about the resulting displays from these commands, see the
OmniSwitch CLI Reference Guide.
OmniSwitch 6624/6648 Network Configuration Guide
Displays interface flow control wait time settings in nanoseconds.
Displays general interface information, such as hardware, MAC
address, input and output errors.
Displays interface accounting information.
Displays interface counters information.
Displays interface error frame information for Ethernet and Fast
Ethernet ports.
Displays collision statistics information for Ethernet and Fast Ethernet
ports.
Displays line status information.
Displays port status information.
Displays inter-frame gap values.
Displays peak flood rate settings.
Displays interface traffic statistics.
Displays auto negotiation, flow, speed, duplex, and cross-over settings.
April 2004
Verifying Ethernet Port Configuration
page 1-19