Rmon Probe Defaults; Quick Steps For Enabling/Disabling Rmon Probes - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Remote Monitoring (RMON)

RMON Probe Defaults

The following table shows Remote Network Monitoring default values.
Global RMON Probe Defaults
Parameter Description
RMON Probe Configuration

Quick Steps for Enabling/Disabling RMON Probes

1 Enable an inactive (or disable an active) RMON probe, where necessary. You can also enable or
disable all probes of a particular flavor, if desired. For example:
-> rmon probes stats 1011 enable
-> rmon probes history disable
2 To verify the RMON probe configuration, enter the
for the type of probe. For example, to display the statistics probes, enter the following:
-> show rmon probes stats
The display is similar to the one shown below:
Entry Slot/Port
-------+----------+---------+-----------+------------+----------------
1011 1/11
3 To view statistics for a particular RMON probe, enter the show rmon probes command, with the
keyword for the type of probe, followed by the entry number for the desired RMON probe. For example:
-> show rmon probes 1011
The display will appear similar to the one shown below:
Probe's Owner: Switch Auto Probe on Slot 1, Port 11
Entry 1011
Flavor = Ethernet, Status = Active,
Time = 11930 hrs 26 mins,
System Resources (bytes) = 272
For more information about these commands, see
"Displaying Statistics for a Particular RMON Probe" on page 24-20
in the OmniSwitch CLI Reference Guide.
page 24-6
CLI Command
rmon probes
Flavor Status
Ethernet Active
"Displaying a List of RMON Probes" on page
OmniSwitch 6800 Series Network Configuration Guide
Default Value/Comments
No RMON probes configured.
show rmon probes command with the keyword
Duration System Resources
11930:27:05 272 bytes
or the "RMON Commands" chapter
Diagnosing Switch Problems
24-19,
November 2004