Removing A Static Neighbor; Configuring And Removing A Static Querier; Configuring A Static Querier - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring IP Multicast Switching
For example, to configure port 4 in slot 10 with designated VLAN 2 as a static neighbor that uses IGMP
Version 3 you would enter:
-> ip multicast static-neighbor 2 4/10 v3

Removing a Static Neighbor

To reset the port so that it is no longer an IPMS static neighbor port you use the no form of the
ip multicast static-neighbor
VLAN number, a space, and either the port (designate the slot number of the port, a slash (/), and the port
number) or linkagg and link aggregation group number.
For example, to remove port 4 in slot 10 with designated VLAN 2 as a static neighbor you would enter:
-> ip multicast no static-neighbor 2 4/10

Configuring and Removing a Static Querier

IPMS static querier ports receive IGMP reports generated on the designated VLAN. Unlike IPMS neigh-
bor ports, they will not receive all multicast streams. The following subsections describe how to configure
and remove a static querier with the

Configuring a Static Querier

You can configure a port as an IPMS static querier port by entering
by the VLAN number (which must be between 0 and 4095), a space, the slot number of the port, a slash
(/), and the port number.
For example, to configure port 4 in slot 10 with designated VLAN 2 as a static querier you would enter:
-> ip multicast static-querier 2 4/10
You can also configure a link aggregation group as an IPMS static querier port by entering
static-querier followed by the VLAN number (which must be between 0 and 4095), linkagg, a space, and
the link aggregation group number.
For example, to configure link aggregation group 7 with designated VLAN 2 as a static querier you would
enter:
-> ip multicast static-querier 2 linkagg 7
By default, the version of IGMP that will be used is Version 2. As an option, you can also specify the
version of IGMP (either version 2 or Version 3) by entering ip multicast static-querier followed by the
VLAN number (which must be between 0 and 4095), a space, either the port (designate the slot number of
the port, a slash (/), and the port number) or linkagg and the link aggregation group number, and either v2
or v3.
For example, to configure port 4 in slot 10 with designated VLAN 2 as a static querier that uses IGMP
Version 3 you would enter:
-> ip multicast static-querier 2 4/10 v3
OmniSwitch 6800 Series Network Configuration Guide
command by entering ip multicast no static-neighbor followed by the
ip multicast static-querier
November 2004
Configuring IPMS on a Switch
command.
ip multicast static-querier followed
ip multicast
page 23-9