Alcatel OmniSwitch 6800 Series Network Configuration Manual page 53

Configuring Ethernet Ports
3
Verify that combo ports 1/47 and 1/48 are set to the default setting of preferred fiber (which will make
the SFP ports 1/47 and 1/48 the primary connections while copper combo ports 1/47 and 1/48 will only
become active if the equivalent SFP ports go down) with the
below:
-> show interfaces 1/45-48 status
Slot/ AutoNego
Port
-----+--------+------+------+------+--------+------+------+------
1/45 Enable
1/45 Enable
1/46 Enable
1/46 Enable
1/47 Enable
1/47 Enable
1/48 Enable
1/48 Enable
FF - ForcedFiber PF - PreferredFiber
FC - ForcedCopper PC - PreferredCopper C - Copper
In the output above combo ports 1/47 and 1/48 are set to preferred fiber. (To configure combo ports as
preferred fiber use the
OmniSwitch 6800 Series Network Configuration Guide
DETECTED
Speed Duplex Hybrid
(Mbps) Type
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
interfaces hybrid preferred-fiber
show interfaces status
CONFIGURED
Speed Duplex Hybrid
(Mbps) Mode
100 Auto FC
1000 Full FC
100 Auto FC
1000 Full FC
1000 Full PF
100 Auto PF
1000 Full PF
100 Auto PF
F - Fiber
command.)
November 2004
Combo Port Application Example
command as shown
Trap
LinkUpDown
-
-
-
-
-
-
-
-
page 1-25