Configuring IP Multicast Switching
Restoring the Querier Timeout
To restore the neighbor querier to its default (i.e., 260 seconds) value you use the no form of the
multicast querier-timeout
-> ip multicast no querier-timeout
Modifying the Querier Aging and Election Timeout
The default IPMS querier aging and election timeout (i.e., the time for which a currently elected querier is
aged and a new multicast querier is elected) is 255 seconds. The following subsections describe how to
configure a user-specified querier aging and election timeout value and how to restore it with the
ip multicast other-querier-timeout
Configuring the Querier Aging and Election Timeout
You can modify the IPMS querier aging and election timeout from 0 to 4294967295 seconds by entering
ip multicast other-querier-timeout
election timeout to 120 seconds you would enter:
-> ip multicast other-querier-timeout 120
Restoring the Querier Aging and Election Timeout
To restore the querier aging and election timeout to its default (i.e., 255 seconds) value you use the no
form of the
ip multicast other-querier-timeout
-> ip multicast no other-querier-timeout
Modifying the Multicast Priority
The default IP multicast priority (i.e., the IP multicast priority value on all IPMS data queues used in the
switch) is low. The following subsections describe how to configure a user-specified multicast priority
value and how to restore it with the
Note. Multicast packets always have higher priority than unicast packets. During heavy multicast traffic
loads, unicast packet loss may result.
Configuring the Multicast Priority
You can modify the IP multicast priority to low, medium, or urgent by entering
followed by low, medium, high, or urgent. For example, to set the multicast priority to urgent you would
enter:
-> ip multicast priority urgent
Restoring the Multicast Priority
To restore the IP multicast priority to its default (i.e., low) value you use the no form of the
priority
command by entering:
-> ip multicast no priority
OmniSwitch 6800 Series Network Configuration Guide
command by entering:
command.
followed by the new value. For example, to set the querier aging and
command by entering:
ip multicast priority
November 2004
Modifying IPMS Parameters
command.
ip multicast priority
ip
ip multicast
page 23-13