Displaying Amap Information - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Using Interswitch Protocols

Displaying AMAP Information

Use the show amap
interfaces, VLANs, and IP addresses. For remote switches that stop sending Hello packets and that are
connected via a hub, entries may take up to three times the common timeout intervals to age out of this
table.
The following example shows three interfaces on a local AMAP switch (4/1, 5/1, 7/1) connected to inter-
faces on two remote switches. Interface 5/1 is connected to a remote switch through a hub.
-> show amap
AMAP:
Operational Status = enabled,
Common Phase Timeout Interval (seconds) = 300,
Discovery Phase Timeout Interval (seconds) = 30
Remote Host 'Switch B' On Port 4/1 Vlan 1:
Remote Device
Remote Base MAC
Remote Interface
Remote VLAN
Number of Remote IP Address(es) Configured = 4,
Remote IP(s) =
18.1.1.1
27.0.0.2
192.168.10.1
192.206.184.40
Remote Host 'Switch C' On Port 5/1 Vlan 7:
Remote Device
Remote Base MAC
Remote Interface
Remote Vlan
Number of Remote IP Address(es) Configured = 1,
Remote IP(s) =
192.206.184.20
Remote Host 'Switch C' On Port 5/1 Vlan 7:
Remote Device
Remote Base MAC
Remote Interface
Remote Vlan
Number of Remote IP Address(es) Configured = 1,
Remote IP(s) =
192.206.185.30
Remote Host 'Switch C' On Port 7/1 Vlan 455:
Remote Device
Remote Base MAC
Remote Interface
Remote Vlan
Number of Remote IP Address(es) Configured = 3,
Remote IP(s) =
192.206.183.10
192.206.184.20
192.206.185.30
OmniSwitch 6800 Series Network Configuration Guide
command to view a list of adjacent switches and their associated MAC addresses,
= OS6800,
= 00:20:da:03:2c:40,
= 2/1,
= 1,
= OS6800,
= 00:20:da:99:96:60,
= 1/8,
= 7,
= OS6800,
= 00:20:da:99:96:60,
= 2/8,
= 255,
= OS6800,
= 00:20:da:99:96:60,
= 4/8,
= 455,
November 2004
Configuring AMAP
page 8-7