Configuring Authentication Ip Addresses; Setting Up The Default Vlan For Authentication Clients - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring Authenticated VLANs

Configuring Authentication IP Addresses

Authentication clients connect to an IP address on the switch for authentication. (Web browser clients may
enter a DNS name rather than the IP address; see
router port is set up for an authenticated VLAN (through the
matically sets up an authentication address for that authenticated VLAN based on the router port address.
The authentication address uses the same mask as the router port address and includes .253 at the end of
the address.
For example, if the router port address for authenticated VLAN 3 is 10.10.2.20, the authentication address
will be 10.10.2.253. This address is modifiable through the
however, must use the same mask as the router port address. For example:
-> avlan auth-ip 3 10.10.2.80
This changes the authentication address for VLAN 3 to 10.10.2.80. The authentication IP address is also
used for the DNS address (see
To display authentication addresses, use the

Setting Up the Default VLAN for Authentication Clients

By default, authentication users cannot traffic in the default VLAN prior to authentication; however, the
switch may be configured to enable the default VLAN so that users may traffic in the default VLAN prior
to authentication.
The default VLAN is the default VLAN for the authentication port, the physical port through which
authentication clients are connected to the switch. The authentication port is specified through the
port authenticate command. See
Use the avlan default-traffic
-> avlan default-traffic enable
When this command is enabled, any authentication client initially belongs to the default VLAN of the
authentication port through which the client is connected. After authentication, if a client is removed from
an authenticated VLAN through the aaa avlan no command, the client is moved to the default VLAN.
To disable any default VLAN for authentication traffic, use the disable keyword with the command:
-> avlan default-traffic disable
WARNING: Traffic on default vlan is DISABLED.
Existing users on default vlan are not flushed.
Users now do not belong to and cannot traffic in the default VLAN prior to authentication. Note that any
existing users in the default VLAN are not flushed.
OmniSwitch 6800 Series Network Configuration Guide
"Setting Up a DNS Path" on page
"Setting Up a DNS Path" on page
show aaa avlan auth-ip
"Configuring Authenticated Ports" on page
command to enable the default VLAN for authentication traffic.
November 2004
Configuring Authenticated VLANs
18-29). When the
vlan router ip command), the switch auto-
avlan auth-ip command; the address,
18-29).
command.
18-28.
vlan
page 18-27