Enabling Rip; Loading Rip - Alcatel OmniSwitch 6800 Series Network Configuration Manual

RIP Routing
Switch 1
RIP Routing Table
VLAN 1
110.0.0.0
110.0.0.1

Loading RIP

When the switch is initially configured, RIP must be loaded into switch memory. Use the
command to load RIP.
To remove RIP from switch memory, you must manually edit the boot.cfg file. The boot.cfg file is an
ASCII text-based file that controls many of the switch parameters. Open the file and delete all references
to RIP. You must reboot the switch when this is complete.
Note. In simple networks where only IP forwarding is required, you may not want to use RIP. If you are
not using RIP, it is best not to load it to save switch resources.

Enabling RIP

RIP is disabled by default. Use the
ple:
-> ip rip status enable
Use the ip rip status disable command to disable RIP routing on the switch. Use the
command to display the current RIP status.
page 13-6
VLAN 2
120.0.0.0
110.0.0.2
RIP Routing
ip rip status
OmniSwitch 6800 Series Network Configuration Guide
Router Port/
=
RIP Interface
Physical
Connection
VLAN 2
120.0.0.0
command to enable RIP routing on the switch. For exam-
Configuring RIP
Switch 2
RIP Routing
VLAN 3
130.0.0.0
130.0.0.1 130.0.0.2
ip load rip
show ip rip
November 2004