Alcatel OmniSwitch 6800 Series Network Configuration Manual page 458

Verifying the ACL Configuration
The following example shows all policy rules configured on the switch:
-> show policy rule
my_rule
Cnd/Act:
+my_rule5
Cnd/Act:
mac1
Cnd/Act:
The display indicates that my_rule is inactive and is not used to classify traffic on the switch (the Inact
field displays Yes). The rule my_rule5 has been configured since the last qos apply command was
entered, as indicated by the plus (+) sign. The rule will not be used to classify traffic until the next qos
apply. Only mac1 is actively being used on the switch to classify traffic.
To display only policy rules that are active (enabled) on the switch, use the show active policy rule
command. For example:
-> show active policy rule
+my_rule5
Cnd/Act:
mac1
Cnd/Act:
In this example, the rule my_rule does not display because it is inactive. Rules are inactive if they are
administratively disabled through the policy rule command, or if the rule cannot be enforced by the
current hardware. Both my_rule5 and mac1 are displayed here because they are active; however,
my_rule5 is a pending rule and will not be used to classify traffic until the qos apply command is entered.
See the OmniSwitch CLI Reference Guide for more information about the output of these commands.
page 22-14
Policy From Prec
cli
cond5 -> action2
cli
cond2 -> pri2
cli
dmac1 -> pri2
Policy From Prec
cli
cond2 -> pri2
cli
dmac1 -> pri2
OmniSwitch 6800 Series Network Configuration Guide
Enab Inact Refl Log Save
0 Yes Yes No
0 Yes No No
0 Yes No No
Enab Inact Refl Log Save
0 Yes No No
0 Yes No No
Configuring ACLs
No Yes
No Yes
No Yes
Matches
No Yes 0
No Yes 0
November 2004