Removing A Static Querier; Configuring And Removing A Static Member; Configuring A Static Member; Removing A Static Member - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring IPMS on a Switch

Removing a Static Querier

To reset the port so that it is no longer an IPMS static querier port you use the no form of the
static-querier command by entering ip multicast no static-querier followed by the VLAN number, a
space, the slot number of the port, a slash (/), and either the port (designate the slot number of the port, a
slash (/), and the port number) or linkagg and the link aggregation group number.
For example, to remove port 4 in slot 10 with designated VLAN 2 as a static querier you would enter:
-> ip multicast no static-querier 2 4/10

Configuring and Removing a Static Member

The following subsections describe how to configure and remove a static member with the
static-member command.

Configuring a Static Member

You can configure a port as an IPMS static member by entering
the IP address of the static member in dotted decimal notation, a space, the slot number of the port, a slash
(/), the port number, a space, and the VLAN number (which must be between 0 and 4095).
For example, to configure a static member with an IP address of 11.0.0.1 on port 10 in slot 3 with desig-
nated VLAN 3 you would enter:
-> ip multicast static-member 11.0.0.1 3/10 3
You can also configure a link aggregation group as an IPMS static member by entering
static-member followed by the IP address of the static member in dotted decimal notation, linkagg, a
space, the link aggregation group number, and the VLAN number (which must be between 0 and 4095).
For example, to configure a static member with an IP address of 11.0.0.1 on link aggregation group 7 with
designated VLAN 3 you would enter:
-> ip multicast static-member 11.0.0.1 linkagg 7 3

Removing a Static Member

To reset the port so that it is no longer an IPMS static member port you use the no form of the
ip multicast static-member
address of the static member, a space, either the port (designate the slot number of the port, a slash (/), the
port number) or linkagg and the link aggregation group number, a space, and the VLAN number.
For example, to remove a static member with an IP address of 11.0.0.1 on port 10 in slot 3 with desig-
nated VLAN 3 you would enter:
-> ip multicast no static-neighbor 11.0.0.1 3/10 3
page 23-10
command by entering ip multicast no static-member followed by the IP
OmniSwitch 6800 Series Network Configuration Guide
Configuring IP Multicast Switching
ip multicast static-member
ip multicast
ip multicast
ip multicast
followed by
November 2004